Driving Sweeping Washing Machine

Don't rush to send the floor cleaning machine for repair when it malfunctions! Ninety percent of Ride-On Floor Scrubber A10/M10 issues can be resolved through simple self-checking steps. Jiechi engineers reveal for the first time the secret manual for quick troubleshooting. Save this article and you'll be all set! Question 1: The water absorption effect deteriorates or it doesn't absorb water at all ✅ Three-step self-check method: Check the red light: See if the red light is on the panel. The machine has a function to stop when it is full of water Check for blockage points: Inspect whether the float ball at the suction port is stuck and whether the sewage pipe is tightly covered Voltage measurement: Use a multimeter to measure the voltage at the water suction motor port (it needs to reach 36V). Question 2: The brush/roller brush suddenly stops working ✅ four-step positioning method: Remove mechanical jamming: Confirm that the brush is not completely worn out and is properly installed Measure the power supply: Use a multimeter to measure the voltage at the brush motor port (around 30V is normal). Check the circuit: Inspect whether the circuit from the controller to the motor is damaged. Carbon brush replacement: Carbon brushes should be replaced first after long-term use (roller brush motors need to be returned to the factory). ⚠️ Note: The voltage output can only be triggered by stepping on the accelerator during measurement Question 3: The equipment cannot move or is weak in movement ✅ Triple inspection points:  Emergency stop switch: Confirm that the emergency stop button is not pressed (the most easily overlooked!). Electronic brake: Measure the brake resistance value (normal value: 64.8±8). Motor power supply: Check the voltage (36V) output from the controller to the walking motor. 🔧Deep treatment: If the resistance is abnormal, the electronic brake needs to be replaced Question 4: Abnormal water output or no water output ✅ Scene-specific processing: No water at all: → Clean the clear water filter → Measure the resistance of the solenoid valve (normal 98±8). Low water output: → Unplug the water pipe to check if the water pump is spraying water → Troubleshoot for clogged water pipes. Extended question: The large water gun doesn't work? Directly measure the on-off status of the switch. Self-checking tool: Interpretation of fault code lights Number of flashes of the light Description Emergency response 1 block The battery is low on power/poorly connected Check the wiring or charge 2 blocks
 The circuit of the walking motor is abnormal Check the connection between the motor and the controller 3 blocks The circuit of the brush plate motor is abnormal Check for damaged or blown circuits 7 blocks Throttle pedal malfunction Replace the pedal (maximum frequency failure) 8 blocks Abnormality in the multi-motor system Check the connections of each motor in sequence